申し訳ありません、このコンテンツはただ今 アメリカ英語 のみです。 For the sake of viewer convenience, the content is shown below in the alternative language. You may click the link to switch the active language.

Metal Powder Industries Federation (MPIF) Design Excellence Award is one of the most prestigious platforms in the Powder Metallurgy (PM) & Metal Injection Molding (MIM) for recognizing achievement in this industry.

“INDO-MIM won 3 Distinction and 3 Grand Prize this year at MPIF Conference

DISTINCTION AWARDS

  • In the Automotive—Engine Category for MIM components, an Award of Distinction has been given to INDO-MIM Pvt Ltd., for a vane lever that is used as a gas flow controller in the turbocharger of an internal combustion engine. The MIM part is made using HK30 austenitic stainless steel that has good oxidation resistance and strength at operating temperatures of 800 to 850 ºC. The part was previously made by machining wrought bar stock

  • In the Automotive—Chassis Category for MIM components, an Award of Distinction has been given to INDO-MIM Pvt Ltd., for an upper cap, lower cap, split center, and split center bleed for a high-end automotive suspension system sub-assembly. The parts are made from MIM-4605
    and heat treated.
  • An Award of Distinction has been given to INDO-MIM Pvt. Ltd. in the Industrial Motors/Controls & Hydraulics Category for MIM components, for a control cone used as a fluid controller in a fuel pump. This is a highly complex part with a cylindrical stepped outer diameter that varies like a dovetail towards one end. The part was previously machined and producing the angular hole through difficult high-volume machining. MIM is far more suitable for high-volume production.

 GRAND PRIZE

  • In the Lawn & Garden/Off-Highway Category for MIM components, a Grand Prize has been awarded to INDO-MIM Pvt Ltd., for a rotor flow meter used in an agricultural sprayer made from MIM-17-4 PH stainless steel. The rotor is used to measure the flow rate of pesticide or fertilizer
    that passes through an extended boom on either side of a carrier while spraying a field. The rotors were previously machined. MIM processing was more cost-effective

  • A Grand Prize has been awarded to INDO-MIM Pvt Ltd., in the Hand Tools/Recreation Category for MIM components for a quick-change core retaining anti-drill part used in a security door lock assembly. The complex part requires high strength and good wear resistance and is made from M2 tool steel. The cube-like structure has four, square through holes and across its center has three cylindrical projections—one at each edge and one in the center.

  • In the Medical/Dental Category for MIM components, a Grand Prize has been awarded to INDO-MIM Pvt Ltd., for a stainless steel curved jaw, part of an advanced bipolar device designed for use in open or laparoscopic tissue sealing surgical procedures.
Automotive Component

Automotive Component

Hydraulic Component

Consumer Component

  

Hand Tool Component

Dental Component